Tuesday, November 23, 2010

Holiday cheer


Are you thinking of your holiday entertaining yet?  Are the neighbours coming over for eggnog?  Here's a project that will net you lots of compliments over the holiday season this year and for many years to come.
These instructions are for one coaster, but of course you can do multiples at the same time using some careful cutting and sewing.
Supplies:  felt (I used white and  green), assorted ribbons from the wonderful Christmas selection, iron-on adhesive (I used Heat & Bond), sewing machine, iron, and a circle template (small dish or can of tuna will do). 
Trace your circle template onto 2 equal sized squares of felt, one white and one green.  (The green felt square below with the circle drawn on it will be the underside of your coaster.)  Cut one same sized square of iron-on adhesive and iron it onto the white felt square.  Peel off backing.  Cut strips of ribbon and lay them onto this side of the felt as shown.  Run the iron over the ribbons once they are all in place.  (There's no need to have all the pieces of ribbon firmly stuck down.  They only need to be held in place sufficiently to allow you to sew them onto the felt backing.)

With your sewing machine on a generous zigzag stitch, sew the ribbons to the felt backing.
Cut another square of iron-on adhesive and iron it onto the back of the ribbon square.   Peel off the backing and place the green felt square back-to-back with the ribbon square (adhesive on the inside).  Run the iron over the ribbon side just until there is a loose bond formed (to hold the two squares together while you sew around the edges).
Turn the bonded squares over to show the green felt backing with the circle marked on it, and cut around the circle.  Cut a loop of red/white twisted rope, knot it, leaving a short 'tail' below the knot.  Peel the two sides of the coaster apart at its top end just enough to insert the tail of rope between them.  Pin in place temporarily while you sew around the edge.
Using the zigzag stitch again sew around the edge of the coaster as shown.
And voila ...!  One coaster ready for a drink!
NOTE:  Of course these little baubles can be used as tree decorations too, so consider them a dual purpose creation.  A set of them would make a great gift, or a single one would be perfect for a teacher gift.
Have fun!
Tilly

3 comments :

  1. Nice idea Tilly. One thought I had is that you could modify the shape of the cut-out to make it look more like a tree ornament (if that's what you wanted to use it for instead of a coaster).

    ReplyDelete
  2. Love Love Love these Tilly. Great project

    ReplyDelete
  3. Oh wow, Tilly!! These are just sooo wonderful! How fun!!

    ReplyDelete

We'd love to hear what you have to say